Commissioned by one of our customers, we received this beautiful original Matchless G3L from the Dutch army for repair. The work we have done is: Engine block: Replace valve cover gasket. Oil supply to the block has been closed due to wet sumping. Change oil. Gearbox: Change oil. Replace clutch plates. Seal primary chain case. Primary…
On behalf of one of our customers who has this beautiful Dnepr K650 with sidecar from 1971, we have to make this motorcycle with sidecar combination roadworthy and ready for inspection so that the customer can have a great season. We had to tackle the following: Engine block: Adjust valves. Replace valve cover gaskets. Replace crankcase cover gasket Replace engine oil (Kroon oil 20W-50). †
On behalf of one of our customers who has owned this beautiful 1949 Panther 250cc for over 45 years, we had this motorcycle in for maintenance and repair. We had to tackle the following: Engine block: Change oil. Gearbox: Change oil. Lubricate grease points with grease. Frame: Revision front fork (Dowty oleomatic lightweight). electrical: …
At the moment another beautiful motorcycle is being built from our stock. A very sporty Rudge 500 cc from 1930. These engines steer and drive perfectly due to their low weight. In 1930 the Rudge motorcycles were ahead of their time. 4-valve technology, coupled brakes, 4 gears, large 8” brake drums both front and rear, the spoke pattern ...
This Triumph CN was bought in England in 1995. The bike was in a bad condition but still quite original (see the photos below). The missing parts were collected together in 10 years. The engine was completed in 2009. Many parts have been recreated, after which everything is nickel-plated. It took some time…
On behalf of one of our customers, we received this beautiful Aermacchi Ala Verde for repair. We had to tackle the following: Connecting and installing electricity properly. Maintenance Oil leaks fixed Adjust the motorcycle Prepare for inspection and request a license plate. Take a test ride After we had done all this, this motorcycle could go back to the ...
This motorcycle arrived with us as pictured above. meanwhile we have already had a lot of work to get this motorcycle back on the road. The work done by us are: Engine block: Engine block disassembled. All parts cleaned. All parts checked for wear. Replaced oil pump and adjusted the new one so that…
This motorcycle arrived with us as pictured above. meanwhile we have already had a lot of work to get this motorcycle back on the road. The activities we performed are: Engine block: Disassembly of the engine block. New bearings installed. Crankshaft oriented. Piston fit perfectly and looked good...
English 
Nederlands